Skip to content
Maintenance & MRO

EASA AD 2026-0219: Shorter De-icing Valve Checks for the ATR 42 and 72

EASA AD 2026-0219, issued 16 November 2026 and effective 30 November, requires shorter repetitive functional checks of the de-icing pressure regulator and shut-off valve on ATR 42 and ATR 72 aeroplanes. It supersedes AD 2025-0011. Comments are open until 14 December.

T
The Flight Brief Editorial Desk

Organizational byline

Updated November 17, 2026

4 min read

An ATR 72 on approach with the landing gear down.
ATR 72 G-FBXB inbound to Sumburgh, 25 September 2020. Photo: Ronnie Robertson. Commons categorises the file as a Loganair ATR 72. Not an ATR 42, and not a serial named in the AD. Wikimedia Commons file, CC BY-SA 2.0. The Commons original is a JPEG, 5,019 by 2,883 pixels. The file on this page is reduced to 1,920 by 1,103 pixels. Height follows the original proportions, rounded to the nearest pixel. The stored file is not cropped.

News. EASA AD 2026-0219 is a final airworthiness directive. It was issued on 16 November 2026 and is effective 30 November 2026. It supersedes EASA AD 2025-0011, dated 10 January 2025. EASA is also taking comments until 14 December 2026. The comment period does not move the effective date.

Which aircraft

The AD applies to ATR 42-200, 42-300, 42-320, 42-400 and 42-500, and to ATR 72-101, 72-102, 72-201, 72-202, 72-211, 72-212 and 72-212A, all manufacturer serial numbers, under type-certificate data sheet EASA.A.084.

It sorts them by whether a modification is already embodied:

  • Group 1 is ATR 42-200, 42-300 and 42-320, all serial numbers.
  • Group 2 is ATR 42-400 and 42-500 on which modification 06076 was not embodied in production and service bulletin ATR42-30-0075 has not been embodied, and ATR 72 aeroplanes on which modification 06076 was not embodied in production and service bulletin ATR72-30-1046 has not been embodied.
  • Group 3 is the ATR 42-400, 42-500 and ATR 72 aeroplanes on which that modification was embodied in production, or the relevant service bulletin has been embodied in service.

Why the interval is shorter

EASA says a design review found that the functional-check interval for each de-icing pressure regulator and shut-off valve (PRSOV), as then published in the maintenance instructions, had to be reduced because of a risk of dormant failures. It says that dormant failure, if not detected and corrected, and combined with icing conditions, could result in loss of control.

AD 2025-0011 required repetitive functional checks after ATR published Airworthiness Operators Message 2024/12 at Issue 3. EASA says later results from the supplier's failure-modes analysis, reflected in ATR's system safety assessment, showed the interval had to come down again. ATR revised the message. For this AD, "the AOM" means 2024/12 Issue 6. The AD says it keeps part of AD 2025-0011 and reduces the repeat intervals.

What the check interval is

Unless already accomplished, a PRSOV functional check is required before exceeding 750 flight hours or 6 months, whichever occurs first, after 24 January 2025, the effective date EASA gives for AD 2025-0011. Repeats then follow Table 1. The table header says the interval is whichever of A or B occurs later.

GroupAB
1190 flight hours since the last PRSOV functional check100 flight hours after this AD's effective date, without exceeding 650 flight hours since the last check
2210 flight hours since the last check100 flight hours after the effective date, without exceeding 700 flight hours since the last check
3160 flight hours since the last check100 flight hours after the effective date, without exceeding 1,050 flight hours since the last check

The check itself is done to the instructions in the AOM. If a check finds a discrepancy, the AD requires the applicable corrective action before next flight, again to the AOM. If the AOM does not correct it, the operator contacts ATR for approved instructions and does those before next flight. EASA says there is no terminating action.

Checks done before 30 November 2026 to Issue 1, 2, 3, 4 or 5 of the AOM count toward the repetitive check. Corrective action done before that date counts if it followed Issue 2, 3, 4 or 5. Issue 1 is not in the corrective-action credit.

Later approved revisions of the AOM are acceptable. The issues EASA lists are Issue 1 dated 24 October 2024, Issue 2 dated 18 November 2024, Issue 3 dated 28 November 2024, Issue 4 dated 30 January 2025, Issue 5 dated 3 March 2025, and Issue 6 dated 26 October 2026.

Sources

The Flight Brief is published by Off The Ground Marketing — aviation marketing for flight schools, charter operators, and MROs.

The weekly brief

Get the stories that matter

Join aviation professionals who start their week with The Flight Brief. One email, the stories that matter. Free. No spam. Unsubscribe anytime.

More stories